Home > Articles > Cisco Network Technology > IP Communications/VoIP > CCNA Portable Command Guide: IPv6

CCNA Portable Command Guide: IPv6

Chapter Description

This chapter provides information and commands concerning a number of IPv6-related topics such as assigning IPv6 addresses to interfaces, IPv6 tunnels, and IPv6 ping.

Static Routes in IPv6

Figure 25-3 illustrates the network topology for the configuration that follows, which shows how to configure static routes with IPv6. Note that only the static routes on the Austin router are displayed.

Figure 25-3

Figure 25-3 Network Topology for IPv6 Static Route Configuration

Austin(config)#ipv6 route 2001:db8:c18:3::/64 2001:db8:c18:2::2/64

Creates a static route configured to send all packets to a next-hop address of 2001:db8:c18:2::2

Austin(config)#ipv6 route 2001:db8:c18:3::/64 fastethernet 0/0

Creates a directly attached static route configured to send packets out interface fastethernet 0/0

Austin(config)#ipv6 route 2001:db8:c18:3::/64 fastethernet 0/0 2001:db8:c18:2::2

Creates a fully specified static route on a broadcast interface

6. Floating Static Routes in IPv6 | Next Section Previous Section