Home > Articles > Configure and Verify Single Area OSPFv2

Configure and Verify Single Area OSPFv2

  • Sample Chapter is provided courtesy of Cisco Press.
  • Date: Dec 27, 2024.

Review Questions

1. What command enters router configuration mode for OSPF version 2?

  1. router ospf 1

  2. router ospf version 2

  3. ospf router version 1

  4. router ospf process 1 version 2

2. You have configured OSPF on a router by using the command network 10.10.0.0 0.0.255.255 area 0. On which interface is OSPF running?

  1. Gi0/0: 10.0.0.1 255.255.0.0

  2. Gi0/1: 10.10.100.1 255.255.255.0

  3. Gi0/2: 10.1.10.100 255.0.0.0

  4. Gi0/3: 10.100.100.1 255.255.255.0

3. What does not have to match in order for an OSPF neighborship to form?

  1. Area ID

  2. MTU size

  3. Hello and dead intervals

  4. Use of the network command versus the ip ospf command

4. You have allowed a router to self-assign its router ID. What is the first option considered for the assignment on the device?

  1. A random router ID assignment

  2. The IP address on the highest-numbered interface name

  3. The highest IP address on a physical interface

  4. The highest IP address on a loopback interface

5. Which network type in OSPF features the use of a DR and a BDR?

  1. Point-to-point

  2. Broadcast

  3. Point-to-multipoint

  4. Point-to-multipoint non-broadcast

7. Answers to Review Questions | Next Section Previous Section

Cisco Press Promotional Mailings & Special Offers

I would like to receive exclusive offers and hear about products from Cisco Press and its family of brands. I can unsubscribe at any time.